AutoCAD Electrical General Discussion

Reply
Contributor
oveimariemamn
Posts: 22
Registered: ‎05-17-2011
Message 1 of 2 (387 Views)
Accepted Solution

WD_M.dwg

387 Views, 1 Replies
12-09-2011 05:02 AM

I get the error: AC electrical can't find the file WD_M.dwg when trying to put a component from IEC list.What is wrong?

*Expert Elite*
rhesusminus
Posts: 899
Registered: ‎09-21-2007
Message 2 of 2 (376 Views)

Re: WD_M.dwg

12-10-2011 02:57 AM in reply to: oveimariemamn

Hi.

 

Check the symbol library paths for the active project. Seems like they are a little bit off. The WD_M block is in one of these folders.

Capture.PNG

 

THL


THL
Please select "Accept As Solution" if this post answers your question. Kudos don't hurt either. ;-)

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community