AutoCAD Electrical General Discussion

Reply
Distinguished Contributor
Gaituuth
Posts: 168
Registered: ‎10-28-2005
Message 1 of 1 (80 Views)

Terminal strip Editor / Tablestyle

80 Views, 0 Replies
08-24-2012 05:22 AM

When I generate a Tabular Terminal Strip I can include the column for Jumpers.

My terminal strip generates OK

So far so good.

But now I want to define the height of the Rows. This goes OK. Except If I have the jumpers column in my table than the minimum row becomes 8.02. With a little bit investigation I found out that a block is inserted in the cell which represents the jumper positions (circles).

The problem is that the name of this block "". Not even a character or somewhat included. I cannot edit it with Bedit because that's giving a message the block name requires at least 1 character.

 

Anyone who know how can I redefine this block so it works well in the future when I generate the strips?

Or where this block is stored. Personnally I think this block is created on the fly. Because I can define the number of circles to show.

 

Regards,

 

Gerald

 

 

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community