AutoCAD Electrical Forum
Welcome to Autodesk’s AutoCAD Electrical Forums. Share your knowledge, ask questions, and explore popular AutoCAD Electrical topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Terminal/Wire number problem

2 REPLIES 2
Reply
Message 1 of 3
twright
204 Views, 2 Replies

Terminal/Wire number problem

How do I keep wire numbers on each side of a terminal to remain the same after inserting a terminal? Typically, a wire being connected to a terminal strip carries the same wire number as the terminal block.
Thanks
2 REPLIES 2
Message 2 of 3
MartinLee
in reply to: twright

It's rather easy. The last part of each wirecut attribute has the same value. Example: The left wirecut attribute is X4TERM01 and the right atrribute is X1TERM01. And if you want top and bottom wirecut points, just be sure that thay have the same number in the last part. After you edit your terminal symbol as above, the wire numbers will "pass through" the terminal as remain the same.
Message 3 of 3
Anonymous
in reply to: twright

At a very basic level, don't use the terminal blocks on the far right side on the menu, those cause the wire number to change. "tomw47" wrote in message news:1275601.1083677905062.JavaMail.jive@jiveforum2.autodesk.com... > How do I keep wire numbers on each side of a terminal to remain the same after inserting a terminal? Typically, a wire being connected to a terminal strip carries the same wire number as the terminal block. > Thanks

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report

”Boost