AutoCAD Electrical General Discussion

Message 1 of 2 (185 Views)

Stand-along cross-ref update

185 Views, 1 Replies
10-20-2003 12:10 AM
Note: the following note originated as an email due to author's inability to
access this news group from his company site. Reproduced here with author's

I was wondering if it's possible to create some programmation line in
autolisp to update signal directly instead of use the «update signal icon»
which we have to click on stand-alone each time and unclick wire update in
the corresponding pop up window.

Message 2 of 2 (185 Views)

Re: Stand-along cross-ref update

10-20-2003 12:13 AM in reply to: *Autodesk\
There is a separate command for Stand-Alone symbol update. It is under the
"Cross-Ref" toolbar flyout. It has the "Stand alone" checked and the "wire
update" unchecked.

Alternately, if you want to try to update a stand-alone symbol by just
picking on it, try this call:

(wd_sig_do_sigs 0 1 nil (list (car (entsel))) nil)

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community