AutoCAD Electrical General

Reply
Active Member
Posts: 6
Registered: ‎12-18-2012
Message 1 of 2 (174 Views)

Source arrows retagging

174 Views, 1 Replies
12-21-2012 10:13 AM

Is there a way to update by retagging all your source arrow and destination arrows at one time through out the project.  I know you can go one by one and right clicking on them and click retag which updates the sheet number and the reference number.  Just want to know if there is a way to update them all through out the hole project.

*Expert Elite*
Posts: 1,056
Registered: ‎03-09-2004
Message 2 of 2 (172 Views)

Re: Source arrows retagging

12-21-2012 11:57 AM in reply to: mtennie

On the Schematics tab, under Edit Wires/Wire Numbers Pulldown, you will find Update Signal References (4 from the left). This will open a a dialog box that will allow you to make project wide Source/Destination arrow updates.

Bob Hanrahan
Ace User since 1998

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community