AutoCAD Electrical General Discussion

Valued Contributor
Posts: 89
Registered: ‎07-13-2005
Message 1 of 2 (163 Views)

Separate contacts

163 Views, 1 Replies
06-04-2012 12:09 PM

Anyone know a way to separate the cross reference contact cross reference locations on a parent coil. I have safety relays that carry NO, NC and NO timed NC timed contacts and would like for those types of contacts to be separated on the parent cross reference not just NO/NC. I have tried table type cross reference format but cant seem to get the type field to display anything but NO/NC

*Expert Elite*
Posts: 899
Registered: ‎09-21-2007
Message 2 of 2 (125 Views)

Re: Separate contacts

10-11-2012 05:08 AM in reply to: breierg

You can always use another pin type (type 4) for the timed NO/NC's. Some work involved, but it will work as expected, especially with table cross-references.


Please select "Accept As Solution" if this post answers your question. Kudos don't hurt either. ;-)

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community