I worked out how to get my components vertical or horizontal by drawing them twice and giving them the same file name i.e VDV11_004 and HDV11_004 but can't seem to get them to flip or reverse...? can somone enlighten me??
Solved! Go to Solution.
I thought I had replied already but evidently not!
Thanks for looking at this for me.
Attached is a DWG with a component I created (a motorised Battery switch used in marine installations) I have shown it vertical and horzontal.
I see your issue now. Flip/Reverse only works with symbols that have only two terninals. With three or more, the software cannot determine everything needed to reroute all the connected wires even if you only have two wires connected.
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.
The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.
|AutoCAD Electrical General|