AutoCAD Electrical General

Reply
*Expert Elite*
testsubject
Posts: 1,072
Registered: ‎03-09-2004
Message 1 of 1 (43 Views)

Removing WIRE layers from Wire Numbering routine.

43 Views, 0 Replies
08-06-2004 08:33 AM
Nate or John Z,

I know that I brought this up before but now that the conduit builder is available I want to revisit this issue. It would be nice if I could select which Wire layers that I want to include in the wire numbering routines. I want to be able to have a layer called Wires-18-ga-MTW-Green but do not want it to be numbered. I do want it to be included in all the other wire utilities though, like conduit sizing. I am sure that I am not the only one that has come across this. I have been placing all my ground wires on a layer that is not a "Wire" layer and they do not appear on my wiring to/from lists. I also use multi-conductor cable that acts the same way. The Cable has its own number and each individual color identifies each wire in the cable so no number is needed.

Thanks in advance,

Robert Hanrahan
Weigh Right Automatic Scale Co.
ACE User since 1998
Bob Hanrahan
Ace User since 1998

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community