AutoCAD Electrical General

Active Member
Posts: 8
Registered: ‎04-28-2004
Message 1 of 2 (81 Views)


81 Views, 1 Replies
05-10-2004 08:16 AM
I was asked why when inserting a coil block at an intersection on a ladder, does i revert to vertical insert.

It should default always to horizontal unless the vertical check box is checked. or you are only on a vertical wire.

Any ideas?

Doug B
*Expert Elite*
Posts: 1,076
Registered: ‎03-09-2004
Message 2 of 2 (81 Views)


05-10-2004 10:23 AM in reply to: DougB
My guess would be because you are trying to insert the coil on an intersection. I would think that the coil would always be inserted on a wire by itself. Since the only continuous wire available at the intersection is the vertical ladder, I guess it is trying to insert it there.
Bob Hanrahan
Ace User since 1998

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community