AutoCAD Electrical General Discussion

Reply
New Member
dmyer
Posts: 2
Registered: ‎08-06-2012
Message 1 of 2 (358 Views)

Problems using MOVE COMPONENT, COPY COMPONENT, SCOOT, etc.

358 Views, 1 Replies
08-06-2012 01:09 PM

Since upgrading to AutoCAD Electrical 2012 (from 2008), I have been having problems when I try to MOVE, COPY, etc., componets.  When I select the component, and then the command, I pick up the component, but as soon as I move the mouse, it immediately drops it (usually above and to the right, outside my title block).  If I use the normal AutoCAD MOVE command, to move other objects, it works perfectly.  Any ideas would be appreciated.

New Member
dmyer
Posts: 2
Registered: ‎08-06-2012
Message 2 of 2 (339 Views)

Re: Problems using MOVE COMPONENT, COPY COMPONENT, etc. (Problem Resolved)

08-07-2012 09:02 AM in reply to: dmyer

The problem has been resolved

 

I am running AutoCAD 2012 under Windows XP Pro, using Parallels Desktop 7.0.15104, on a MacMini.  After making several attempts at mouse configuration changes, and downgrading Parallels to version 7.0.15054, to no avail, I removed the mouse driver loaded by Parallels version 7.0,15104 (in Windows).  When I rebooted, the original Logitech mouse driver reloaded and the issues were resolved.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community