AutoCAD Electrical General

Reply
Active Contributor
laki.anu87
Posts: 41
Registered: ‎12-24-2012
Message 1 of 1 (91 Views)

Problem with Wire number by using Cirucit Builder Concept

91 Views, 0 Replies
06-25-2013 04:54 AM

 

Hi,

 

Any one help me how to slove this Problem.

 

While I am trying to insert the circuit by using " Circuit Builder Concept" (as shown in the image below) it is showing two different wire numbers (K3A & 34) for the same wire. I need it to be K3A. How do I do it?

 

Untitled picture.png

 

 

Untitled picture1.png

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community