AutoCAD Electrical General Discussion

Reply
Contributor
croland
Posts: 25
Registered: ‎03-19-2009
Message 1 of 2 (109 Views)

Problem with PDB blocks (DB)

109 Views, 1 Replies
01-09-2012 12:14 PM

I am currently using AE 2012 and having problem with the power distribuion block electrical symbol.  I can not get AE to label wires on bothside of a pole.  It only labels one wire and the other one is left unlabeled.  The wire being use is marked to be labeled and there is no wire numbers on a hidde layer either. 

 

*Expert Elite*
Icemanau
Posts: 930
Registered: ‎06-01-2010
Message 2 of 2 (102 Views)

Re: Problem with PDB blocks (DB)

01-09-2012 02:17 PM in reply to: croland

It sounds like you have a block that is passing the wire number through.

 

Try inserting a wire number copy after the distribution block. If the block is passing the wire number through, your copy will reflect that.

 

Regards Brad

Icemanau (NNTP handle: Brad Coleman)


You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community