AutoCAD Electrical General Discussion

Reply
Active Contributor
Alain1851
Posts: 26
Registered: ‎03-18-2011
Message 1 of 1 (43 Views)

Problem layer and file extension dwg

43 Views, 0 Replies
12-08-2011 07:33 AM

Hello,

 

When I work on my portfolio, I am on the current layer 0.

 

And when I insert the wire, sometimes I end up with the current layer as the layer "wires" and with the thickness of the line "0.00" instead of "BYLAYER". which meant that when I print, I have not the right thickness for the j'utile "monochrome.ctb".

 

And sometimes the file extension dwg is capitalized.

 

Does anyone has seen this?

And why I do that?

Thank you for your answers

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community