AutoCAD Electrical General

Reply
Contributor
matthewjohnston4386
Posts: 22
Registered: ‎06-29-2011
Message 11 of 12 (100 Views)

Re: Power Bus using Terminal Blocks with 4 entry points

08-05-2011 08:11 AM in reply to: Icemanau

Okay, I see that now! I didn't even know this tool existed.  I think that with this combined with placing the block in a smart fashion will be a good solution.

 

Thank you so much!

 

Matthew Johnston

Matthew Johnston
Sr. Controls Scientist
Corning Inc.
Distinguished Contributor
iomaxx
Posts: 178
Registered: ‎03-03-2006
Message 12 of 12 (59 Views)

Re: Power Bus using Terminal Blocks with 4 entry points

01-31-2013 08:17 AM in reply to: matthewjohnston4386

Just curious if you finalized how you did things. I use the same 4connection terminals, and I have them set up as 4 level terminals (should i set them as 2level though?), and when working on a schematic drawing, I just have to be aware of the need to place a terminal every 4th connection on an I/O bus. I haven't been able to figure out how to make use of the wire connection sequence tool though.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community