AutoCAD Electrical Forum
Welcome to Autodesk’s AutoCAD Electrical Forums. Share your knowledge, ask questions, and explore popular AutoCAD Electrical topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Populate Panel from schematic list, not marking existing

2 REPLIES 2
Reply
Message 1 of 3
Anonymous
404 Views, 2 Replies

Populate Panel from schematic list, not marking existing

Hello,
I've been using the populate panel from schematic list feature in autocad. I just ran a project resequence/retag on a set of drawings. After the run, i opened populate panel from schematic list again. I reloaded the program, and selected marked existing. However, the program will not mark some inserted footprints even though I see that they were inserted earlier from populate panel from schematic list. I've re-built the project database, reloaded populate panel, and still see the same problem. Does anyone have any suggestions?

Thanks,
~Mark
2 REPLIES 2
Message 2 of 3
cashea
in reply to: Anonymous

I am having the problem noted above.  I am taking the following steps:

 

  1. "Schematic List" in Panel.
  2. Press "Reload"
  3. Press "Mark Existing"
  4. Components which exist on the panel are not being marked as existing.

Smiley Mad

 

 

Message 3 of 3
cashea
in reply to: Anonymous

If found the problem.  My footprint block had an "FPT" (Terminal Footprint) attribute.  The footprint was identified as a terminal rather than a component.

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report

”Boost