AutoCAD Electrical General Discussion

Reply
New Member
JohnDV
Posts: 1
Registered: ‎02-06-2004
Message 1 of 2 (44 Views)

PLC 32 pt modules

44 Views, 1 Replies
02-06-2004 06:56 AM
I am building standalone 32 pt plc modules. They are set up with 16 pts on the left ladder and 16pts on the right. They insert fine individually but not with the spread sheet. The first module comes in fine and its addressing is fine. However, subsequent symbols and rung comments for the right side come in on top of the left side. In addition, if multiple modules are in the spread sheet, the 2nd module will not start a new page but comes in on top of the right side of the previous module.
Valued Contributor
dlshood
Posts: 78
Registered: ‎02-10-2004
Message 2 of 2 (44 Views)

Re: PLC 32 pt modules

02-10-2004 01:03 PM in reply to: JohnDV
John,
Make sure that your Parametric module file contains only 16 Address line type attributes.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community