AutoCAD Electrical General Discussion

Reply
Distinguished Contributor
amt_controls
Posts: 112
Registered: ‎12-23-2003
Message 1 of 1 (59 Views)

Multi-Bom not on Panel

59 Views, 0 Replies
12-23-2003 09:13 AM
For example, I create a multi-bom item in the schematic consisting of a fuse holder and a fuse as item 01. In the panel layout drawing the schematic components list shows two items, the fuse holder and the fuse listed with the same tag ID.

I have been creating dumb blocks, one for the holder and one for the fuse. This creates an accurate BOM, but the multi-bom hierarchy is lost in the panel BOM report.

The exception report then reports that the mult-bom item 01 is missing as well as multiple instance and part number mismatch.

What is the correct procedure for linking the multi-bom hierarchy from the schematic to the panel layout and panel BOM.

Thank you

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community