AutoCAD Electrical General

Reply
New Member
Phil69
Posts: 2
Registered: ‎02-26-2013
Message 1 of 3 (201 Views)

Moving groups of connector pins

201 Views, 2 Replies
02-26-2013 07:09 AM

I am extremely new to AutoCAD Electrical and need to stretch a connector and move a group of connector pins down the stretched connector. I know how to stretch the connector symbol, but is there an easy way of moving a group of the connector pins other than the "Move Connector Pins", which appears to only move one pin at a time?

*Expert Elite*
Icemanau
Posts: 911
Registered: ‎06-01-2010
Message 2 of 3 (186 Views)

Re: Moving groups of connector pins

02-26-2013 02:17 PM in reply to: Phil69

Use the Stretch PLC command.

 

When you do so, make sure to include the pins you wish to move. This will explode the block, strecth (or move) the selected section and the recreate the block.

 

Regards Brad

Icemanau (NNTP handle: Brad Coleman)


New Member
Phil69
Posts: 2
Registered: ‎02-26-2013
Message 3 of 3 (169 Views)

Re: Moving groups of connector pins

02-27-2013 06:59 AM in reply to: Phil69

Thank you for your help Brad. Much appreciated.:smileyhappy:

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community