AutoCAD Electrical General Discussion

AutoCAD Electrical General Discussion

Reply
Member
michaelupholz
Posts: 3
Registered: ‎09-17-2012
Message 1 of 2 (85 Views)

Manual or ICON insert on PANEL

85 Views, 1 Replies
09-24-2012 12:27 PM

When I insert a symbol on the "Panel" from the "Panel" Tab. the items show up just fine. When i run the BOM report it doesn't show up at all.

I need this more importantly when inserting a base, and cpu for a PLC. As I understant it, this is the only way to have those items show up on the panel layout and BOM.

 

What could I be doing wrong? cant seem to find and details regarding this.

 

 

Member
michaelupholz
Posts: 3
Registered: ‎09-17-2012
Message 2 of 2 (84 Views)

Re: Manual or ICON insert on PANEL

09-24-2012 12:32 PM in reply to: michaelupholz

I found it!. I was using the "Reports tab - Schematic" I should have been using the "Reports Tab - Panel"

 

 

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.
Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.