Currently when I place a wire gauge and color it is displayed above the wire. I would like to have it automatically displayed under the wire. Is their a place to change this? I find it time consuming and a pain to have to move every single wire label. I am using AutoCAD Electrical 2013. Any suggestions would be helpful.
I use the Flip Wire Number command. But not sure if there is any setting to change to skip this step.
Schematic tab> Edit Wires/Wire Numbers panel> Flip Wire Number.
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.
The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.
Upgrading to a 2015 product? Make sure to check these out 1st!