AutoCAD Electrical General

Reply
Member
emmanueld
Posts: 3
Registered: ‎06-05-2012
Message 1 of 1 (130 Views)

Looking to have two form C visible in the table of cross reference

130 Views, 0 Replies
02-12-2013 01:48 PM

Hi,

 

I'm looking for being able to have two form C block using "Symbol Mapping" of table cross-reference format setup like the picture I post.

 

Because I use a component with Contact form C and Limit Switch form C, I would like to be able represent a contact form C when I link contacts to my parent and represent LS form C when I link LS to my parent.

I would like to be able to show both of them for SP child too.

 

So what I need to modify in the symbol mapping and in the pin list, if it's possible.

 

Thanks

 

Emmanuel D.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community