AutoCAD Electrical General Discussion

Reply
Active Contributor
laki.anu87
Posts: 41
Registered: ‎12-24-2012
Message 1 of 2 (307 Views)

Customised Circuit by using Circuit Builder

307 Views, 1 Replies
01-17-2013 01:16 AM

Hi,

 

I have created the circuit in .dwg format and saved it in \Autodesk\Acade 2013\Libs\jic125, but am not able to call customized circuit from circuit builder by using spread sheet (ACE_CIRCUIT_BUILDER.XLS). I have updated the spread sheet in sheet ACE_CIRCS in DWG_TAMPLATE column. Please help me solve this issue.

Distinguished Contributor
s.wile
Posts: 136
Registered: ‎12-08-2008
Message 2 of 2 (289 Views)

Re: Customised Circuit by using Circuit Builder

01-17-2013 08:41 AM in reply to: laki.anu87

What is the exact name of the block? Verify that the block name matches.

You could try inserting the block it into the drawing before running CB. That would make sure its not a path issue but a CB issue.

Stan Wile
http://myacade.blogspot.com/
IMAGINiT Technologies

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community