AutoCAD Electrical General

*Expert Elite*
Posts: 1,056
Registered: ‎03-09-2004
Message 1 of 3 (280 Views)
Accepted Solution

Changing the Terminal TAG-ID

280 Views, 2 Replies
01-24-2013 01:32 PM

I know I am just missing something simple, but  how do you change a group of terminals Tag-ID on a schematic without using Find/Replace/Project Rebuild? I know I could change each one individually using edit terminal. Looking to change a bunch.


I am using ACE 2013.



Bob Hanrahan
Ace User since 1998
*Expert Elite*
Posts: 866
Registered: ‎06-01-2010
Message 2 of 3 (275 Views)

Re: Changing the Terminal TAG-ID

01-24-2013 02:19 PM in reply to: testsubject

Go into the Terminal Strip editer and select the terminal strip that has the terminals you wish to change.


Select ALL the terminals you wish to change the ID on and then right click on one of the selected terminals.

From the list, choose terminals then REASSIGN.


Now just change the Strip ID as required.


Note that this is from the 2008 version, so it should still be available in the 2013 release, but you may have to hunt a bit for the commands


Regards Brad

Icemanau (NNTP handle: Brad Coleman)

*Expert Elite*
Posts: 1,056
Registered: ‎03-09-2004
Message 3 of 3 (259 Views)

Re: Changing the Terminal TAG-ID

01-25-2013 06:23 AM in reply to: Icemanau

Thanks Brad!


I knew it had to be something simple but I was just not seeing it.

Bob Hanrahan
Ace User since 1998

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community