AutoCAD Electrical General Discussion

Reply
Distinguished Contributor
chubby-1
Posts: 157
Registered: ‎07-05-2005
Message 1 of 1 (40 Views)

Cables

40 Views, 0 Replies
10-28-2005 12:35 PM
Is it possible to have a cable with a "fan-out" on 1 end and a single connection on the other? I have tried using a "fan-out" source arrow and a "single" destination arrow.....but......that lists one end in the cable report and the other end in the wire report. Any help would be appreciated.

Thanks
Marty

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community