AutoCAD Electrical General

Reply
Active Contributor
Posts: 36
Registered: ‎07-02-2008
Message 1 of 1 (59 Views)

Border Swap

59 Views, 0 Replies
07-29-2011 05:47 AM

After reading the thread below, I worked through swapping out title blocks/borders.

However, when I choose 1 block at a time, browse to location, and check retain old block scale and swap block, the new one does not adopt the old scale. Am I missing something? The title block text also looses any edits that may have been done (i.e. reduced width). Any help would be greatly appreciated.

Richard

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community