Ray,
There is currently not a mechanism in place to assign and report wire
information (other than wire "layer", wire number, and cable conductor info)
to individual wires. There is a back-door way to assign connection
information like lug type and other information and have it show up in the
from/to reports. You could associate a TERMDESCxx attribute to each X?TERMxx
wire connection attribute, make it hidden, and encode your connection
information on this attribute. For terminals, the attribute name is
X?TERMDESC01 where ?=1,2,4, and 8 for the four wire connections.
With this in place, in the from/to reports your data will show up, I
believe, under the "PD1" and "PD2" report columns (wire connection point
descriptions). Note: most of the stock AcadE schematic symbols do not have
this extra attribute in place for each wire connection.
Nate.
"srayc" wrote in message
news:14341759.1086372620643.JavaMail.jive@jiveforum1.autodesk.com...
> Is there any method to associate additional information to the wires drawn
on the scheme? I'm looking to add terminal(lug) information, wire markmarker
type, shield info...
>
> Ray C.