AutoCAD Electrical General

Reply
Distinguished Contributor
mako68
Posts: 118
Registered: ‎12-11-2007
Message 1 of 2 (223 Views)

Add or Remove features?

223 Views, 1 Replies
04-05-2013 04:24 AM

Hi,

 

AutoCAD Electrical 2013 installed from USB stick (Product Design Suite).

 

Need to modify installation (add new manufacturer data). Go to Control Panel  and select "Add or remove features" after modifying ACADE is asking to insert disc 2 of 3 of AutoCAD Electrical?

Try with USB stick...no help -> Cannot continue.

 

Is this known bug?

 

Mentor
algerj
Posts: 219
Registered: ‎02-25-2010
Message 2 of 2 (172 Views)

Re: Add or Remove features?

04-09-2013 06:59 AM in reply to: mako68

Hi Mako,

 

I have seen the Issue a few times, it seems to forget where the MSI file is.

Normally after selecting the MSI file for ACADE from the USB stick it works.

You need to select the MSI file when it asks for the disc (9 times out of 10 it is searching for the MSI fie), browse to your usb and find the MSI file below.

 

It should be in a location similiar to this one: (E: Drive being my USB Drive, also mine is product design suite ultimate APDSU...)

E:\APDSU2013\x64\Acade\ ACAD.MSI

 

I hope this helps,

 

Regards,

 

James Alger

SolidCAD

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community