AutoCAD Electrical General

Reply
Active Member
AScorgie
Posts: 7
Registered: ‎07-20-2010
Message 1 of 3 (429 Views)

ACADE 2012 Multiple balloon insert gone wrong

429 Views, 2 Replies
03-01-2012 08:30 AM

When inserting a balloon for a component that has multiple catalog references, the balloons are not inserted adjacent to each other. To get them aligned I must UnGroup the inserted balloons and then drag them into postion.

 

Is there a way to correct this insertion problem?

*Expert Elite*
dougmcalexander
Posts: 3,001
Registered: ‎10-18-2003
Message 2 of 3 (418 Views)

Re: ACADE 2012 Multiple balloon insert gone wrong

03-01-2012 02:53 PM in reply to: AScorgie

Be sure you haven't changed the balloon Direction options.  Version 2012 features the option to assign the direction of the additional balloons (i.e. up, down, left, right).  It will remember the last setting used.  Watch the command line prompt as you are inserting balloon leaders (see attached screen capture).  I haven't seen any negative issues wit this new feature, but you have to be aware that it will default to the last setting.  I always use angle with last segment.

Doug McAlexander
Independent Consultant/Instructor/Mentor specializing in AutoCAD Electrical, ecscad, and promis-e implementation

Web site: www.ECADConsultant.com
Phone: (770) 841-8009

Please Accept as Solution if I helped you. Kudos are also much appreciated.
New Member
jonathan.myerchin
Posts: 1
Registered: ‎07-02-2012
Message 3 of 3 (329 Views)

Re: ACADE 2012 Multiple balloon insert gone wrong

07-02-2012 06:24 AM in reply to: AScorgie

I am also having a problem with this.  Has there been any resolution found?

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community