AutoCAD Electrical General

Posts: 219
Registered: ‎05-24-2011
Message 1 of 2 (119 Views)

A Different Wire Number Question

119 Views, 1 Replies
01-14-2013 06:42 PM

Hi Folks


I have been using the border X/Y cordinate system for Xref and wire numbers and it is working very well.


I have been looking at having the rung numbers vertical like on the AEGS04 Tutorial drawing in the Title block folder.


IE  the sheet number followed by the ladder number.


All changers I make the only format I can achieve is    Ladder number followed by the sheet number.


My need is learning, I am not being held up on a project.


Thanks  John Quigley



Distinguished Contributor
Posts: 135
Registered: ‎12-08-2008
Message 2 of 2 (89 Views)

Re: A Different Wire Number Question

01-17-2013 12:36 PM in reply to: johnq

It may help if you posted examples of what your after and what you currently have.

Stan Wile
IMAGINiT Technologies

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Manufacturing Community
The Manufacturing Community provides additional access to tips, tutorials, blogs and networking with peers.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Electrical Category!

The AutoCAD Electrical forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community