AutoCAD Civil 3D

[#1]

The cross sections do not display the correct cross slope for superelevated sections. I have redefined the templates and regions and checked the SE parameters. I have also edited the design control for each individual section. Still, the cross slope is not correct. Does anyone have any points or tips for additional settings I may have missed, or has anyone experienced the same problem? Any input would be welcome.

[#2]

Beth, You're in the wrong newsgroup. This one is for the new Civil 3D program - which doesn't have road sections yet. Try posting to the autodesk.land-desktop newsgroup. Glen "Beth Schatz" wrote in message news:11740739.1077189348914.JavaMail.jive@jiveforum2.autodesk.com... > The cross sections do not display the correct cross slope for superelevated sections. I have redefined the templates and regions and checked the SE parameters. I have also edited the design control for each individual section. Still, the cross slope is not correct. Does anyone have any points or tips for additional settings I may have missed, or has anyone experienced the same problem? Any input would be welcome.

[#3]

Hi Beth, When you Edit the Design Control for individual sections, the software assumes you know what you are doing and does not calculate those sections. [Cross-sections][Design control][Reset Design Control] will remove all your hand editing and allow the system to compute the Super-elevation. If your super-elevation is still not showing then there will be an error somewhere in your setup of the super-elevation. -- Laurie Comerford CADApps www.cadapps.com.au "Beth Schatz" wrote in message news:11740739.1077189348914.JavaMail.jive@jiveforum2.autodesk.com... > The cross sections do not display the correct cross slope for superelevated sections. I have redefined the templates and regions and checked the SE parameters. I have also edited the design control for each individual section. Still, the cross slope is not correct. Does anyone have any points or tips for additional settings I may have missed, or has anyone experienced the same problem? Any input would be welcome.

[#4]

Are you using the "Process Sections" after editing the design control? "Beth Schatz" wrote in message news:11740739.1077189348914.JavaMail.jive@jiveforum2.autodesk.com... | The cross sections do not display the correct cross slope for superelevated sections. I have redefined the templates and regions and checked the SE parameters. I have also edited the design control for each individual section. Still, the cross slope is not correct. Does anyone have any points or tips for additional settings I may have missed, or has anyone experienced the same problem? Any input would be welcome.