AutoCAD Civil 3D

[#1]

how can i get my shoulder slope to match my lane slope? there is a feature line with elevation that is following the end of my lane (off: 33.50'). but from there, i cant get my shoulder slope to match my lane slope. i cant set another profile for the 35.5' offset to follow and need this to work. see image, dont worry about the left side.

thanks.

[#2 · Accepted solution]

Use a parameter reference in your assembly.  This will allow the program to apply an output parameter from one sub as an input for another one.

[#3]

you are using assemblies that i'm not using. i cant get the assemblies you used to do what i need. i have specific alignments and elevations i need to follow and that sub doesnt have the juice i need, sorry. is there possibly another method you or anyone else can think of to help me out, i am stuck here... thank you SBoon.

[#4]

Need more detail.  Post a sketch showing which subs you're using and how the assembly was built.  We'll also need to know which ones are being controlled by corridor targeting.  Can you post a drawing with the assembly in it?

[#5]

What shoulder SA are you using? They should all have that override built in to allow the lane slope to be passed to the shoulder.

Regards,

Peter Funk

Autodesk, Inc.

[#6]

right now i am using a "lanesuperelevationAOR" defined by a feature line and elevation, and a "shoulderextendsubbase". i also have a "linkoffsetandelevation" before the lane.  you can see it in the image on the original post. i thought i went through the definition of the shoulder looking for something like that, but if there is another one i need to use i gladly switch. thanks.

[#7]

SUCCESS! ok, i found the option to have it follow the lane slope. thanks to everybody that posted!