AutoCAD Civil 3D
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
Surface edit / data reference
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
77 Views, 0 Replies
03-14-2012 01:28 PM
I have surface created from an xyz point file, today I had to extend the surface but the new data was in a .asc file. I edited the surface definition by adding dgm...no problem, however the surface was data referenced into another drawing (B) and post edit drawing (B) won't open? I went back and deleted the new data and then drawing (B) was ok. Can anyone point out where I'm going wrong ??
