AutoCAD Civil 3D Wishes

Posts: 798
Registered: ‎06-08-2007
Message 1 of 1 (66 Views)

offset profile problem needs fixing

66 Views, 0 Replies
10-05-2012 02:58 PM

after you sample offset profiles on a ground surface (say large). then when moving the design profile arnoud there is a large delay. what it's doing is probably regenerating the offset profiles. when taken away doesn't have the problem.


i don't see why this should be a problem since the offset profile has nothing to do with design profile.


2013 not sure 2012 definitely have the problem. but i doubt it will be fixed in 2013. just a rare thing probably only i use.

Civil 3D 2012
Work: Xeon W3503, 12GB, Quadro 2000, Yamakasi Sparta 301 + Dell PH2211
Home: 3930k, 12GB, GTX 590, U3011, QX2710

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community