Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I am getting a message in the events panorama that says "Failed to add boundary 1" when I try to add an outer boundary to my surface. I clearly is adding the boundary, however, as it shows up in the surface and the contours trim back to it. I'm just curious as to why that message is popping up.
I had problems adding a boundary when my corridor crossed back over itself at a corner that was too sharp. I increased the radius of the curve until the corridor stopped crossing over itself, and had no problems after that.
