AutoCAD Civil 3D General

Reply
Valued Contributor
pardo24
Posts: 84
Registered: ‎08-31-2005
Message 1 of 3 (121 Views)

no corridor shown in cross sections

121 Views, 2 Replies
09-20-2007 09:44 AM
i used the create assembly offset command and built my assembly off of this new starting point, created a corridor which i then viewed in view/edit sections, looks fine, then i created x-sections and my corridor does not display in my cross sections! any thoughts?
*Matt Kolberg
Message 2 of 3 (121 Views)

Re: no corridor shown in cross sections

09-20-2007 01:22 PM in reply to: pardo24
Offset assemblies do not appear in cross section views. You can basically
treat them as completely separate baselines. You can't show multiple
baselines in section views either.

Matt
Contributor
James Bell
Posts: 17
Registered: ‎02-22-2007
Message 3 of 3 (121 Views)

Re: no corridor shown in cross sections

10-17-2007 09:08 AM in reply to: pardo24
Matt,
What is the best way to cut cross sections? I have cut them using a surface (built from my corridor model). This shows everything I need except for my pavement thickness'. I asked our trainer about this and he said to cut the sections from my corridor model and it will show all of the pavement thickness'. I did this and it worked. However, when one of my 50' cross sections is in the middle of an intersection it only goes out to the edge of pavement. (I ran my typical assembly with curb & gutter up to the curb return. Then I ran a typical assembly without curb and gutter through the intersection. Then ran a curb return assembly around each curb return) Is there any way to show the pavement thickness and the "true" cross section all the way through the swath width that I have set? Again, what is the best way to handle cross sections? Attached, you'll see the plan of the cross section 106+75, the cross section that I'm getting, and the cross section I want to get. Thanks for any and all help you can give me.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Civil 3D Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for AutoCAD Civil 3D helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Civil 3D

Twitter

Facebook

Blogs