AutoCAD Civil 3D General

Reply
Contributor
glacoste
Posts: 20
Registered: ‎05-27-2010
Message 1 of 2 (124 Views)
Accepted Solution

generic subassembly point coding best practices

124 Views, 1 Replies
02-07-2013 09:25 AM

what are the best practices for coding these subassemblies do you use L1 and R1 to seperate the left from right or do you keep both sides the same code. where is there a good tutorial on this?

 

Gerry

Valued Mentor
fcernst
Posts: 1,086
Registered: ‎01-07-2011
Message 2 of 2 (119 Views)

Re: generic subassembly point coding best practices

02-07-2013 09:42 AM in reply to: glacoste

Typically keep the same code because Subassmblies have a "Side" parameter so that you can use the Subassembly on both sides of your Corridor.

Fred Ernst, PE
C3D 2015
Ernst Engineering
www.ernstengineering.com

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Civil 3D Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for AutoCAD Civil 3D helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Civil 3D

Twitter

Facebook

Blogs