Hi all I have a question about alignments broadening. By SNIP broadening must be done at the expense of shoulders. How can I do it?
Thanks.)
From what little you've said, I *think* you might be asking about offset alignment widening.
Give this link a read and if that's not what you're after, come back and give us some more details as to what you're trying to do.
http://docs.autodesk.com/CIV3D/2014/ENG/filesCTU/GUID-8208038F-7522-44C1-8DBC-5AAC9D789107.htm
Don Ireland
Engineering Design Technician
By SNIP offset alignment widening must be done at the expense of shoulders. How can I do it?
I hope that now my question is correct))
X man:
I would think that your shoulder could be LinkOffsetAndSlope Subassembly ( similar). One side of the Subassembly will be controlled by the pavement edge (using an alignment) and the outside will also be controlled by another alignment so that the shoulder will vary to your requirements.
Bill
Thank you for good idea , I will try ).It's my Subassembly shoulder(see attachment)