alignment bugs

[Anonymous]

I guess there is a bug in alignment editor. When i modify the alignment, it suddenly showed gaps in alignment although chainage values continue. I tried to delete the parts but it does not allow me to do it. I stuck.

Please review the pics.

[Anonymous]

murat_celen wrote:
> I guess there is a bug in alignment editor. When i modify the
> alignment, it suddenly showed gaps in alignment although chainage
> values continue. I tried to delete the parts but it does not allow me
> to do it. I stuck.
>
> Please review the pics.

More than a JPEG the actual drawing file (with just the alignment) would
be very useful. Also information on how you created the alignment. If
it was from a polyline, would you include the polyline also? Thanks.

--
Himanshu Gohel. Civil 3D Team, Autodesk, Inc.
Autodesk Civil 3D Product Information: http://www.autodesk.com/civil3d
Civil Engineering Community Portal: http://civilcommunity.autodesk.com

[Anonymous]

The alignment was not vreated by pline but with the existing tools. Please review the alignment around Km 12+000. I guess i found the bug. It is because of the label marks. If you zoom extend and drag the label a bit, it seems to correct. But if you revize again, the same bug continues.

Please review the drw attached.

Note : i cannot seem to attach the file. It would be better if i send you by email. Please reply with an email address.

Best Regards

Murat Celen

[Anonymous]

murat_celen wrote:
> Note : i cannot seem to attach the file. It would be better if i send
> you by email. Please reply with an email address.

Since Himanshu is an Autodesk employee, his address follows their
convention - first name dot last name at autodesk dot com.



--
Jason Hickey

Civil 3D 2007, SP3
Dell Precision M70
2 GIG RAM, 256 MB nVidia Quadro FX Go1400
Intel Centrino 2 gHz Processor

www.civil3d.com