Video Card Trouble?

[bgriffin291]

Anybody ever have this going on? If you can't tell, it is a parking lot layout with finished grade contours and a few spot grades.

See the attached. This is the only drawing that this happens to so I don't think it is the video card. I can open other dwgs that are much larger with no problems at all. This dwg is only 850kb.

It happend a couple time last week, but I was able to close and re-open and everything was fine.

Any suggestions?

[AllenJessup]

Two thoughts from having seen this in the wayback. Toggle Display Lineweights on and then back off. Type Plan on the command line and set to World.
I seem to remember this happening when working in MS through a layout VP or maximized VP and then toggling back to MS.
Allen

[bgriffin291]

This is something different. The drawing appears to open normally, but as soon as I zoom in or out or try to pan around, then it messes up.

I am not working in MS through a VP, just in plain old MS.

I'm afraid that the file has been corrupted somehow.

[AllenJessup]

Try an Audit then. I still remember that when I saw that type of screen it had something to do with the lineweight display.
Allen

[bgriffin291]

I used the PLAN command and set to World and so far everything is working as normal.

Thanks.

[bgriffin291]

I take it back, it only worked for a short while. I tried putting in some more spot grades and it messed up again. Tried the PLAN command, toggling lineweights, purge, audit, etc. Nothing.

Any other suggestions?

[Kyle-Evans]

Try a "-purge" getting rid of the REGAPPS, then do another audit, and save