I've seen it fairly often, especially while doing a lot of corridor section edits. I think that there's a way to turn off the undo function and then turn it back on again. When you do that the program apparently starts a new file.
... I think that there's a way to turn off the undo function and then turn it back on again. ...
Undo, Control, None or One
Undo, Control, All
I have done this so many.....times today. It doesn't work. Software is Civil 3D 2013. A couple of computers have the message "Warning! Undo has been disabled in order to prevent undo file overflow. You may re-enable it via the undo command. The undo file length was 1768915703 bytes". I've been using the UNDO command since Release '08 & I've never seen this problem. I have search & search & nothing seems to work....how do you control the length of the UNDO command. I don't understand how UNDOCTL works cause it's read only. Does anyone have a solution?
C'mon "Experts" stop just telling everyone to "Save and Restart" Obviously, there is an issue that needs to be resolved. Put that "Expert" title to use.. Geez!
In their defense, I would say that the suggestions offered are the best known workaround(s).
These guys are peers using the software like all of us, and do not have a hotline to the programmers / software architects.
Thanks for the "constructive" criticism, clevelandw, but I don't see any usable advice from you at all on this issue.
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.