I have an existing surface that was created using points that were found not to be good (bad elevations & coordinates shifted). The point problem has been addressed. What I do not want to do is completely re-build the surface. I would like to use the existing definitions (break lines, triangle edits, etc.) along with the good points to re-build the surface. I did not originally build this surface, the person that did no longer works at our firm. Therefore, if I cannot do something as outlined above, then I will have to start from scratch. Yay. Also, for new standard purposes, the surface needs to be in an individual dwg.
Thanks
Kris
dont worry about a full vs partial rebuild. Civil3d will rebuild what has to be rebuilt upon the removal of the erroneous point. Just take them out of the definition.
Joe Bouza
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Will all of the breaklines, triangle edits, etc. update as well? How do I address completly removing the surface from the existing dwg and moving it to a new dwg?
Thanks
Kris
neilyj (No connection with Autodesk other than using the products in the real world)
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Joe Bouza
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.