AutoCAD Civil 3D General

Reply
RDW
Active Member
Posts: 8
Registered: ‎10-22-2003
Message 1 of 2 (57 Views)

Surface creation

57 Views, 1 Replies
12-02-2004 08:33 AM
I’ve noticed that in Civil 3D, creating a surface from contour data requires turning off / removing all data but the contours as there is no option to “select contours by layer” as in LDDT.

Am I missing something obvious?
*Dave Simeone
Message 2 of 2 (57 Views)

Re: Surface creation

12-02-2004 01:22 PM in reply to: RDW
Howdy - Unfortunately this is a known limitation with R2005. We've got this listed as a requirement for future releases. For now you can isolate the layer OR use the AutoCAD selection set functionality (ie, build a selection set before running the command and then use the selection set when promoted to select plines). Thanks DAS "RDW" wrote in message news:12021516.1102005211102.JavaMail.jive@jiveforum1.autodesk.com... > I've noticed that in Civil 3D, creating a surface from contour data requires turning off / removing all data but the contours as there is no option to "select contours by layer" as in LDDT. > > Am I missing something obvious?

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Civil 3D Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for AutoCAD Civil 3D helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Civil 3D

Twitter

Facebook

Blogs