AutoCAD Civil 3D General

Reply
Active Contributor
Aistis88
Posts: 41
Registered: ‎01-28-2013
Message 1 of 2 (138 Views)

Subbassembly composer codes and targets , problem in corridor parameters

138 Views, 1 Replies
09-09-2013 10:52 PM

I create assemblys using "Autodesk subassembly composer ". I import them and build a corridor from them.   If i make corridor from one assembly with "pave offset target" and other "target to surface" i have to set those targets in corridor. Problem is  - if that corridor have like for example 10 regions, i have to set same targets for  all regions and its is quite difficult , couse usually i have like 2-3 assemblys with different construction but the same targets and like 20-30 regions , so if my corridor  must target pave offset i have to set that SAME target for the right and for the left side 30x2 = 60 times.

 

Is there any possibility that could remove this misery ?

 

Distinguished Contributor
nilesh33
Posts: 103
Registered: ‎07-08-2009
Message 2 of 2 (105 Views)

Re: Subbassembly composer codes and targets , problem in corridor parameters

09-10-2013 02:34 AM in reply to: Aistis88

Hi,

 

It's same procedure even if you are using autodesk stock subassemblies.

But you can set "Surface Target" for all regions at once by selecting "Set Targets All Targets" in corridor properties.

(Select option click here to set all)

 

For offset targets, I would suggest you to create one small region with all offset targets and apply this region for full length. Then split this region into smaller once according to your assemblies.

 

Hope it will help you.

 

Regards,
Nilesh J
Civil 3D 2012, SAC
16 GB Ram 64 Bit Win7

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community


Civil 3D Exchange Apps

Created by the community for the community, Autodesk Exchange Apps for AutoCAD Civil 3D helps you achieve greater speed, accuracy, and automation from concept to manufacturing.

Connect with Civil 3D

Twitter

Facebook

Blogs