Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
Hi there. I'm trying to determine the best subassembly to be used for the attached cross-section. I'm trying out the DaylightBasin2, but I don't see a way to control the depth of the ditch in a cut situation. Fill is simply 4:1. Am I missing something? What subassembly would be best for this scenario?
use the daylight min offset from the edge of your subbase, let it daylight on the exist (set your slope), attach a link width slope subassembly to the bottom of the daylight subassembly with targets of a alignment and profile for the ditch bottom. (dont forget to hardcode your slope to the subassembly
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")