Community
I have a custom subassembly created in SAC 2012 (pkt file is attached). Among other things, it has two Aux points (AP2 and AP4). There is a decision statement that says AP2.x > AP4.x. But it's throwing an error message "x is not a Member of Double".
Don Ireland
Engineering Design Technician
If a reply solves your issue, please remember to click on "Accept as Solution". This will help other users looking to solve a similar issue. Thank you.
Please do not send a PM asking for assistance. That's what the forums are for. This allows everyone to benefit from the question asked and the answers given.
I just found the problem. I had created two output params AP4 and AP2 because I wanted to display the X values at run time. I just realized that I blundered by naming them the same as my point names.
So now the question is HOW do I delete the output params?
Don Ireland
Engineering Design Technician
If a reply solves your issue, please remember to click on "Accept as Solution". This will help other users looking to solve a similar issue. Thank you.
Please do not send a PM asking for assistance. That's what the forums are for. This allows everyone to benefit from the question asked and the answers given.
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
