The delete option is not fast enough?
Or the condensed versionEditFeatureCurve. It's funny that Help [in 2011] says the command supports 2D & 3D polylines and Lines. Since none of those support curves.
Me too. Reading this board helps open them.
Tying to be helpful by testing a solution - I just crashe c3d and lost an hours worth of work
In any event, I think you can only straightne a FL that has been previously Smoothed, otherwise it delete curves.
Very sorry about that Joe. I see you're burning the weekend oil too. I tried tracking down a couple of blogs that hinted you could use Pedit-Straighten. But you can't use Pedit on Featurelines.
I suppose you could explode the FL, Pedit it and turn it back to an FL. I ended up deleting the curve, adding a straight featureline and joining that back to the remaining segments.
Again. My regrets. No chance of recovering an Autosave file?
No worries, yes I have many backup.
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.