Project objects to profile view - using surface elevations

[zrawe16]

I've been using this tool to project 3D Polylines to my profile view and the line doesn't look like it picks up an elevation at every TIN line that it crosses - only from the two end points of the line. So my lines aren't actually representing the surface at that line. Is there a way to make the line pick up all the elevations of the tin lines??? Thanks...

[Anonymous]

Turn it into a feature line and apply surface elevations to it making sure
you specify that intermediate grade break points are added.

--

Matt Kolberg
GCS - A Division of Cansel

[zrawe16]

I am still getting the same results. I doesn't seem to recongnize the elevations where it crosses the TIN, just the beginning and ending points.

[Anonymous]

Hmmm, I suppose because they are elevation points and not PI's. I never
actually tried. If you explode that you should get a 3D polyline with those
points turn into PI's.

--

Matt Kolberg
GCS - A Division of Cansel


wrote in message news:6272885@discussion.autodesk.com...
I am still getting the same results. I doesn't seem to recongnize the
elevations where it crosses the TIN, just the beginning and ending points.