Profile View horizontal geometry bands

[harold.alberto]

Hi All,

I'm using C3D 2012.  I created a profile view for a straight horizontal alignment.  The band label for the horizontal won't appear for this particular straight aligment.  I have a few other alignments that has curves in it and the profile view displays the labels fine.

I tried to create a new straight alignment again, create a profile view but I get the same results.

I also tried it on a new drawing using the NCS metric template with same results.

Has anyone experienced this before?  

The only solution I can think of (if this is a bug) is to extend my alignment by say 0.1m and add a new IP at the correct alignment end, mask that on plan and end my profile view to the right length. 

Thanks 

Harold

[Joe-Bouza]

It appears to not label the horizontal band if there is only the start and end PI. if I add a PI it give two length labels. I assume the developers felt and alignment with only two PI's was described fully by the stationing?

[harold.alberto]

Thanks very much Joe.

Is it the same on 2013? 

[Joe-Bouza]

Apparently so. HTH

[harold.alberto]

Thank you.

I understand that the length of the alignment maybe shown on the stationing.  But what about the other alignment properties that may be added to the band like direction, start/end northing and easting, etc.

I'm pretty sure it was working on 2010/2011. 

[Joe-Bouza]

I hear ya.