Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I am having issues having two separate areas combined into one with subcriteria. While I can get them to figure independently of each other (see image 1) I need to have them combined into a single fill category. While I think I am using the subcriteria interface correctly I can’t find an example of a way to set it up to work correctly (see image 2).
Dave, thanks for asking question. I am having the same trouble. The subcriteria functionallity would be great but I have not ever had any luck with it. Have you come accross a solution since your original post?
I never did get the sub-criteria to work. The only thing I have worked out for the average end calculations was to use the “total volume” table (which combines all cut categories and fill categories) in combination with the “material” table.
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")