I need to set a numbe rof points on an existing surface. Each point is giving me an elevation of 0.0 which of course is not the surface elevation. I'm sure this is a setting, but cannot find where the default setting is located. Thanks.
Solved! Go to Solution.
You can also assign elevations to the points after creation from the Modify tab of the Ribbon click the Point button. When the Contextual Points Ribbon displays you will see a button for Elevations from Surface.
When I set manual points I will typically create one point, copy it all over the place and then use that comand to save time on the command line.
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.